Pin Wheel Birthday!!!

This card is made with the retiring Celebrations DSP & the new hostess set Happiest Birthday Wishes.

To create the pin wheel you use a 3 1/2" x 3 1/2" piece of DSP. Line the opposite corners up in the track of your paper cutter and cut down at an angle 1 1/2" on all four corners. With the paper piercing tool poke a hole in the end edge of one of the flaps on all corners (same flap on each corner, ie left or right side). Fold & line holes up and place a brad in the center. (this is the tricky part and takes some time)

Details for creating this card:

5 1/2" x 8 1/2" Natural Ivory CS - scored at 4 1/4"

4 1/4" 1 1/2" DSP & 4 1/4" x 1" DSP & 3 1/2" x 3 1/2" DSP

Dotted Scallop Ribbon Punch of extra DSP (for pinwheel pole)

Happiest Birthday Wishes - new Hostess Stamp set.

Thanks,

Jen

Tweet